Alert: Notifications and correspondence during COVID-19 restrictions
We are operating at reduced capacity due to the COVID 19 Alert Level Two requirements. Find out more about how to correspond and notify us during this time.
You might also hear from us as we proactively call businesses about how they're operating safely during Alert Level Two.
Sheet metal moves in two axes (towards the back or front of the machine, and from side- to-side). When the tool begins to work, the sheet metal stops and the tool powers down to perform its operation.
While this guidance has not been updated to reflect current work health and safety legislation (the Health and Safety at Work Act 2015 and regulations), it may still contain relevant information and practices to keep workers and others healthy and safe.
Please read this guidance in conjunction with all relevant industry standards that apply to you as a PCBU. This guidance will be progressively reviewed and either updated, replaced with other guidance, or revoked.
On simple machines the operator will fasten the tool in the tool holder. On more complex machines, CNC instructions will tell the tool holder to select a tool from a magazine, and then carry out the programmed operations.
On some machines, the sheet metal is fixed, and the tool holder moves to the point of operation.
The CNC turret punch can perform the following operations:
- Basic punching Extruding
- Slotting and recessing Forming tabs
- Creating ribs
- Creating hinges
The tool will form, mark, or cut out shapes from the metal sheet. Scrap metal falls through the machine bed for collection. Completed products are collected from the machine bed.
Figure 1: CNC turret punch
- Contact or impact from moving parts/unwanted movement
- Hands or fingers trapped by tools/tool holder
- Slips, trips and falls
- Contact, impact or trapping from unexpected movement (during maintenance, cleaning & repairs)
Personal protective equipment (PPE)
- Ear protection
- Eye protection
Task – Load/unload materials
- DO NOT operate the turret punch during loading and unloading.
Task – Machining process (tool selection, programmed operations)
Hands or fingers trapped by tools/tool holder
- Crush injuries
- DEFINE a “no go” area around the machine, where entry is detected and machine movement stopped until the area is clear.
- ENSURE that shutting down the main source of power also prevents unsafe operation of the control system.
Most tools operate so close to the sheet metal that they actually operate as a closed tool, that is, too close to the workpiece for fingers to reach between the workpiece and stripper plate. If the purpose of the tool is to form a shape above the sheet metal, eg. spikes on gang nails or louvres on the side of a cabinet, the tool may present an open space as it lifts above the sheet.
Other (non-mechanical) hazards
- Hearing damage or loss
- REDUCE noise levels by isolating machines or enclosing within noise barriers.
- ASSESS noise levels.
- ARRANGE hearing screenings.
- ALWAYS WEAR hearing protection.
A safe noise level over an eight hour day is 85db(A). A CNC turret punch may exceed this noise intensity.
Slips, trips and falls
- Contact or impact injuries
- KEEP up-to-date housekeeping procedures.
- KEEP the area around machines clear of slip and trip hazards.
Task – Maintenance, cleaning & repairs
Contact, impact or trapping from unexpected movement
- Crush injuries
- LOCK-OUT all power supplies before maintenance, cleaning and repairs.
- KEEP written safety procedures, and ARRANGE regular inspections by a competent person.
- REMOVE or LOCK-OUT machines that fail inspection, and DO NOT USE until repaired or replaced.
- When a machine is altered, eg. changes to guards or barriers, a new hazard assessment MUST be carried out, and safety improvements made.
Download fact sheet